Operator`s manual

MAINTENANCE AND SERVICING

Form 169000 / 169040 117 Revision C

7.6.4 Sealed Bearing Installation

a. Clean shaft and coat with rust preventative.

b. Install flangette (A), bearing (B), second

flangette (C), and lock collar (D).

NOTE

The locking cam is only on one side of

the bearing.

c. Install (but do not

tighten) the flangette bolts (E).

d. When the shaft is correctly located, lock the lock

collar with a punch.

NOTE

The collar should be locked in the same

direction the shaft rotates. Tighten the

set screw in the collar.

e. Tighten the flangette bolts (E).

f. Loosen the flangette bolts on the mating bearing

one turn, and re-tighten. This will allow the

bearing to line up.