Operator`s manual
MAINTENANCE AND SERVICING
Form 169000 / 169040 105 Revision C
SAMPLE GREASE DECAL
7.6 LUBRICATION
CAUTION
To avoid personal injury, before servicing
header/mower conditioner or opening drive
covers, follow procedures in Section 7.1
PREPARATION FOR SERVICING.
Refer to Section 7.3.2 Recommended Fluids
and Lubricants for recommended greases.
The greasing points are marked on the machine
by decals showing a grease gun (A), and grease
interval (B) in hours of operation.
Log hours of operation and use the
"Maintenance Checklist" provided to keep a
record of scheduled maintenance. Refer to
Section 7.18 MAINTENANCE SCHEDULE.
7.6.1 Greasing Procedure
a. Wipe grease fitting with a clean cloth before
greasing, to avoid injecting dirt and grit.
b. Inject grease through fitting with grease gun until
grease overflows fitting, except where noted.
c. Leave excess grease on fitting to keep out dirt.
d. Replace any loose or broken fittings
immediately.
e. If fitting will not take grease, remove and clean
thoroughly. Also clean lubricant passageway.
Replace fitting if necessary.
7.6.2 Lubrication Points
The lubrication requirements depend on the
model of header/mower conditioner that is being
serviced.
Refer to the specified pages for identifying
lubrication points for your specific model:
A30-S HEADER Pages 106 - 107
A30-D HEADER Pages 108 - 109
A40-D HEADER Pages 110 - 111
HAY CONDITIONER Page 112
DRIVELINES Page 113
PULL-TYPE CARRIER Page 114