Operator`s manual

MAINTENANCE AND SERVICING

Form 169000 / 169040 104 Revision C

7.4 DRIVESHIELDS

a. To open the LH and right driveshields on the

header, press a screwdriver against latch in

opening at (A).

CAUTION

Ensure shield lock engages in the “open”

position as shown at (B) before letting go of

shield.

b. To close, push shield slightly farther open and

move lock (B) out of engagement slot. Lower

shield by hand, and release about 12 in.

(300 mm) from “fully closed” position. Shield will

self-latch.

c. To open the driveline shield, disengage rubber

latch (C), and open shield (D).

d. To close, lower shield and engage rubber latch.

7.5 LIFT CYLINDER LOCK-OUTS

7.5.1 Self-Propelled

Refer to your Windrower Operator’s Manual.

7.5.2 Pull-Type

DANGER

To avoid bodily injury or death from

unexpected start-up or fall of raised

machine; stop engine, remove key and

engage lift cylinder lock-out valves before

going under machine for any reason.

a. Raise the header fully, shut off engine, and

remove key.

b. Move handle to “horizontal” position on both

header lift cylinder lock-out valves.