User`s manual

BIOS SETUP
MB700 User’s Manual 45
PCI VGA Active Monitor
When enabled, any video activity restarts the global timer for Standby
mode. The default setting is Enabled.
Soft-Off by PWR-BTTN
This field defines the power-off mode when using an ATX power supply.
The Instant-Off mode allows powering off immediately upon pressing the
power button. In the Delay 4 Sec mode, the system powers off when the
power button is pressed for more than four seconds or places the system
in a very low-power-usage state, with only enough circuitry receiving
power to detect power button activity or Resume by Ring activity (see
next field) when pressed for less than 4 seconds. The default value is
Instant-Off.
Power On by Ring
An input signal on the serial Ring Indicator (RI) line (in other words, an
incoming call on the modem) awakens the system from a soft off state.
Resume by Alarm
This allows a computer to be turned on automatically through the timer
set in the BIOS to make the system more schedulable. By default, this
field is set to Disabled.
IRQ 8 Break Suspend
You can enable or disable the monitoring of IRQ 8 (Real Time Clock) so
it does not awaken the system from Suspend mode.
Reload Global Timer Events
This section determines the reloading of the ‘timers’ after entering the
Full On You can enable or disable the monitoring of IRQ 8 (Real Time
Clock) so it does not awaken the system from Suspend mode.