User Manual

‰ 7
Basic Operation (continued)
(2) Changing the Channels
Changing channels with the CHANNEL UP (CH ∑ ) or DOWN (CH ≈ ) button on the remote control
Press the CHANNEL UP (CH∑) button and the channels change in the order shown below:
1 → 2 → 3 → … → 98 → 99 → 0 → 1 → 2 → 3 → …
Press the CHANNEL DOWN (CH≈) button and the channels change in the order shown below:
3 → 2 → 1 → 0 → 99 → 98 → … → 3 → 2 → 1 → …
• Channels that have been set to SKIP cannot be selected. (Please see page 11 for details on Skipping Channels.)
• When selecting the channel using the CHANNEL UP (CH∑) or DOWN (CH≈) button on the TV set, AV mode
is positioned as follows:
Channel up: 1 → 2 → 3 → … → 98 → 99 → AV → 0 → 1 → 2 → 3 → …
Channel down: 3 → 2 → 1 → 0 → AV → 99 → 98 → … → 3 → 2 → 1 → …
Changing channels using the CHANNEL SELECT buttons on the remote control
• To handle the increasing number of channels available, this TV set allows you to select up to 100
positions (Channel 0 to 99). One-digit and two-digit methods of selection can be used. Follow the
procedure shown below to select channels.
0
1
4
7
2
5
8
3
6
9
CH
CH
To select a one-digit channel (e.g.,
Channel 5):
(1) Press the
5
button.
(2) If “5-” is indicated and the picture
does not change, press the
button to switch over to the 1-digit
select mode and press the
5
button again.
To select a two-digit channel (e.g.,
Channel 15):
(1) Press the
button to set the
2-digit select mode.
(2) Press the
1
button.
(3) Press the
5
button.
5
PAL
B/G
0
1
4
7
2
5
8
3
6
9
CH
CH
• In this mode entering a 0 first will
enable selection of single digit
channels e.g. 07.
• Complete this procedure within 6
seconds, otherwise the selection
will not be made.
(3) Adjusting the Volume
15
1
-
-
-
PAL
B/G
TIMERFUNCTION PICTURE
CH
CH
Press the VOLUME UP ( ) or DOWN
(
) button to adjust the volume.
The number of oval blocks “
” indicates
volume level.
The display disappears approximately 3
seconds after the volume adjustment
has been completed.
VOLUME
(TV set)