Specifications

WPM SERIES
5. Installation
Remove an already installed PSU from the case. Proceed as follows:
1. Switch off your PC. Disconnect the PSU’s power cord from the wall outlet and your PSU. Unplug all
cables connected to the PC case (e.g. keyboard, mouse etc.).
2. Open the PC case (for additional information refer to the PC case’s manual).
3. Disconnect all cable connections between the PSU and other PC components (e.g mainboard, HDDs,
drives, fans etc.).
4. Remove the mounting screws connecting PSU and PC case and carefully take the PSU out of the case.
5.1 Installing the PSU into the PC case
1. Insert the PSU into the PC case and put it against the PSU bracket on the case’s back side.
2. Screw the PSU to the case from the outside using the included screws. Pay attention not to cover the
fan/air intake of the built-in PSU.
5.2 Connecting the PC components to the PSU
5.2.1 The connectors at a glance
Connector
20+4-pin ATX power
connector
4+4-pin P8 power con-
nector
6+2-pin PCIe power
connector
6-pin PCIe power con-
nector
Type
1x attached 1x attached 1x attached 1x modular
Connector
SATA power connector
4-pin connector for
peripheral devices 4-pin floppy connector
Type
6x modular 5x modular 1x modular

8