Operation Manual

www.sharkoon.com
SATA QUICKPORT INTERN SINGLE-BAY Manual
Features:
• Internaldockingstationforone2.5"SATAharddiskdrive/SolidStateDisk
• Suitableforone3.5"PCdrivebay
• FastSwapmechanismforeasyhandling
• CompatiblewithSATAI,IIandIII
• Transferrate:max.6Gb/s
Package content:
• SATAQuickPortInternSingle-Bay
• 1xSATAdatacable
• 1xinternalYpowercable
• Setofmountingscrews
• Manual
Short manual:
1. SwitchoffyourPCanddisconnectthepowercord.
2. OpenthePCcase.
3. Removethe3.5"mountingbay’sfrontbezel.
4. Slidethedockingstationintothemountingbay.
5. Attachthedockingstationfrombothsidesinsidethemountingbayusing
 theincludedscrews.
6. Connectthedockingstation’sSATAdatacabletotherespectiveSATA 
 connectoronthemainboard(forfurtherinformationalsorefertoyour
 mainboard’smanual).
7. PlugtheinternalYpowercabletothepowerconnectorsonthedocking
 station’sbacksideandtothematchingpowerconnectorofyourPSU.
Note:
Brand new HDDs used with the QuickPort Intern must be
partitioned and formatted. Proceed as described below (e.g. Windows XP):
Start / Settings / Control Panel / Administrative Tools / Computer Management /
Disk Management. Click the respective HDD with the right mouse button and
choose partition/format.