Installation Guide

4
Tel: [phone]
|
Fax: [phone]
To Connect
To Disconnect
Keep product clean in a bag until ready to use.
1. Depressurize the system.
2. Turn locking cap quarter turn counter clockwise.
3. Push against release collar and pull pipe to release.
Tube Stop O-Ring
Support Washer Stainless Steel
Teeth Grip Pipe
Release Collar
How to make a
ProLock Connection
Step 1: Push
When cutting SharkBite PE-RT Pipe,
ensure that the ends are cut square and
the surface is smooth. Ensure that both
the ProLock ttings and pipe are clean
and free of debris. Push pipe onto tting.
Step 2: Twist
Turn the locking cap quarter turn
clockwise to the locked position, an
audible click will be heard.
Step 3: Lock
To ensure that the tting has been
locked, check to make sure the indicator
marks are aligned.
Tel: [phone]
|
Fax: [phone]