How to Guide

35
5001 E. Philadelphia Street, Ontario, CA 91761-2816 • [phone] • Fax [phone] •
www.iapmort.org
CERTIFICATE OF LISTING
IAPMO Research and Testing, Inc. is a product certification body which tests and inspects samples taken from the supplier's stock or from the market or a combination of both
to verify compliance to the requirements of applicable codes and standards. This activity is coupled with periodic surveillance of the supplier's factory and warehouses as well
as the assessment of the supplier's Quality Assurance System. This listing is subject to the conditions set forth in the characteristics below and is not to be construed as any
recommendation, assurance or guarantee by IAPMO Research and Testing, Inc. of the product acceptance by Authorities Having Jurisdiction.
Effective Date:
December 2014 -Rev. 10/7/2015-
Void After: December 2015
Product:
Crosslinked Polyethylene (PEX) Tubing
File No. 9143
Issued To:
CASH ACME/RELIANCE WORLDWIDE
2400 7TH AVE. SW
CULLMAN, AL 35055
Identification:
The tubing shall be marked with the manufacturer's name or trademark, ASTM
F876, PEX, pressure rating at 180°F, nominal size, SDR 9, and a code number
identifying the compound and the date of manufacture. The tubing intended
for use in potable water shall be marked with the seal or mark of the
laboratory marking the evaluation. Marking shall be spaced at intervals of
not more than 5 feet. Tubing shall be marked with the cUPC® certification
mark.
Characteristics:
Crosslinked polyethylene (PEX) tubing that is outside diameter controlled,
made in standard thermoplastic tubing dimension ratios (SDR 9), and pressure
rated for water at three temperature. 630 psi (4.34 MPa at 73.4°F (23°C) 400
psi (2.76 MPa at 180°F (82.2°C) 315 psi (2.17 MPa at 200°F (93.3°C). May be
used in radiant floor and baseboard heating applications. To be installed in
accordance with the manufacturer's instructions and the requirements of the
latest edition of the Uniform Plumbing Code® and the National Plumbing Code
of Canada.
Products listed on this certificate have been tested by an IAPMO R&T
recognized laboratory. This recognition has been granted based upon the
laboratory's compliance to the applicable requirements of ISO/IEC 17025.
Products are in compliance with the following code(s):
Uniform Plumbing Code (UPC®)
National Plumbing Code of Canada
Products are in compliance with the following standard(s):
ASTM F876-2013a and CSA B137.5-2013
For a complete list of compliant models and the most up to date listing, please visit
http://pld.iapmo.org/file_info.asp?file_no=0007143
10/9/2015