How to Guide

33
5001 E. Philadelphia Street, Ontario, CA 91761-2816 • [phone] • Fax [phone] •
www.iapmort.org
CERTIFICATE OF LISTING
IAPMO Research and Testing, Inc. is a product certification body which tests and inspects samples taken from the supplier's stock or from the market or a combination of both
to verify compliance to the requirements of applicable codes and standards. This activity is coupled with periodic surveillance of the supplier's factory and warehouses as well
as the assessment of the supplier's Quality Assurance System. This listing is subject to the conditions set forth in the characteristics below and is not to be construed as any
recommendation, assurance or guarantee by IAPMO Research and Testing, Inc. of the product acceptance by Authorities Having Jurisdiction.
Effective Date:
October 2015
Void After: October
2016
Product:
Lead Free Plumbing Products
File No. 6544
Issued To:
CASH ACME/RELIANCE WORLDWIDE
2400 7TH AVE. SW
CULLMAN, AL 35055
Identification:
Each product shall bear permanent and legible markings to identify the
manufacturer. This marking shall be the trade name, trademark, or other mark known
to identify the manufacturer. The product and/or product packaging may also bear
the term "Lead Plumbing Law", "Complies with Lead Plumbing Law", or either "Lead
Free" or "Low Lead" above or in close proximity to the appropriate IAPMO R&T
certification mark, or the term "Certified by IAPMO R&T". The product packaging
may also bear a grey dot, a check mark with circle, or any other home centers
marking requirements.
Characteristics:
Products may include any pipe, pipe fitting, solder, flux, or other plumbing
products providing water for human consumption. Products listed below are to be
installed in accordance with the manufacturer's instruction. These products have
been verified with weighted average lead content <=0.25%; Solder and flux lead
content <=0.2%.
Products listed on this certificate have been tested by an IAPMO R&T recognized
laboratory. This recognition has been granted based upon the laboratory's
compliance to the applicable requirements of ISO/IEC 17025.
Products are in compliance with the following standard(s):
Section 1417(d) of the Safe Drinking Water Act
The lead content requirements of Section 116875 of the California Health & Safety
Code
NSF/ANSI 372-2011
For a complete list of compliant models and the most up to date listing, please visit
http://pld.iapmo.org/file_info.asp?file_no=0006544
10/9/2015