How to Guide

31
IAPMO RESEARCH AND TESTING, INC.
5001 E. Philadelphia Street, Ontario, CA 91761-2816 • [phone] • Fax [phone] •
www.iapmort.org
CERTIFICATE OF LISTING
IAPMO Research and Testing, Inc. is a product certification body which tests and inspects samples taken from the supplier's stock or from the market or a combination of both
to verify compliance to the requirements of applicable codes and standards. This activity is coupled with periodic surveillance of the supplier's factory and warehouses as well
as the assessment of the supplier's Quality Assurance System. This listing is subject to the conditions set forth in the characteristics below and is not to be construed as any
recommendation, assurance or guarantee by IAPMO Research and Testing, Inc. of the product acceptance by Authorities Having Jurisdiction.
Effective Date:
July 2015 -Rev. 10/2/2015-
Void After: July 2016
Product:
Push Fit Fittings
File No. 4630
Issued To:
Cash Acme/Reliance Worldwide
2400 7TH AVE. SW
CULLMAN, AL 35055
Identification:
Each fitting shall have the following information marked on it where it will
be visible after it has been installed:
Name of manufacturer or trademark.
When a fitting is not suitable for all four (4) materials, it shall be marked
as follows for the materials for which they are suitable:
- Copper or Cu
- CPVC
- PEX
- PE-RT
When push-fit connectors are used on plumbing devices, the markings are
permitted to be on the plumbing device.
Fittings 1/2" CTS or smaller are permitted to use a permanent label complying
with the requirements of UL 969 or CSA C22.2 N. 0.15 to display the required
markings. The markings shall be permanent. The product shall also bear the
cUPC mark.
Characteristics:
Push fit fittings that have a quick assembly push fit mechanism that can be
used with Copper, PEX and CPVC tubing and pipes. Fittings for use in domestic
and commercial application for both potable water distribution systems and
hydronic heating systems. Push fit fittings can be utilized in underground
applications and as manufactured joints without access panels. To be installed
in accordance with the manufacturer's instructions and the latest edition of
the Uniform Plumbing Code and the National Plumbing Code of Canada.
10/9/2015