Operation Manual

10
FREEPHONE 0800 862 0453
If the brush roll stops
moving, it’s probably due
to the anti-jam feature.
This feature protects the
motor from becoming
overheated. If the brush
becomes overloaded, it will
stop turning and both speed
indicator and the first LED
light will flash. Turn off your
unit by pressing the power
button once. See page 12
for further instructions
on removing or cleaning
the brush roll. Wait for 10
seconds to let your unit cool
down. Now press the power
button again and you’re
ready to resume cleaning!
1 Press the power button to start
the unit. When finished cleaning,
press the power button again to
turn the unit off. (Fig. 4)
2 When turning on the unit, the
speed setting will automatically
go to HI. You can adjust the
speed of the brush roll to suit
the floors that you are cleaning.
Press the speed button to switch
between speeds.
One light “LO” indicates the
speed optimized to clean bare
floors and two lights “HI”
indicate the speed optimized to
clean carpets and larger debris
on bare floors. (Fig. 5)
USING YOUR SHARK
®
CORDLESS SWEEPER
3 The telescopic tube is designed
to adjust to the height that is
comfortable for all users. To
adjust the height, push down the
release button on the telescopic
tube and pull the handle up to
adjust it to a comfortable height
for using. (Fig. 6)
4 Do not use the unit to pick up
liquids or clean wet floors.
5 Do not use the unit on concrete,
tar or other rough surfaces.
6 Do not use the unit to pick up
pieces of string or fabrics. Do
not use the unit to clean tasseled
or frayed carpets.
Fig. 6
Fig. 4
Fig. 5