OWNER’S GUIDE V2950 www.sharkclean.
IMPORTANT SAFETY INSTRUCTIONS For Household Use Only READ ALL INSTRUCTIONS BEFORE USING YOUR SHARK® CORDLESS FLOOR AND CARPET SWEEPER. WHEN USING YOUR SHARK CORDLESS FLOOR AND CARPET SWEEPER, BASIC SAFETY PRECAUTIONS SHOULD ALWAYS BE OBSERVED, INCLUDING THE FOLLOWING: 14 DO NOT put any object into openings. Do not use with brush roll blocked; keep free of fiber, lint, hair and anything that may prevent the brush roll from working.
TO MAXIMIZE THE LIFE OF YOUR NI-MH BATTERIES: 1 Charge for 7 hours before initial use. Failure to do so will reduce the product’s battery life significantly. 2 Always remove the charging adapter fom the unit after the charging period has completed. 3 Do not store the unit with the charging adapter attached and plugged in. 4 For maximum battery life, only recharge the unit when the batteries are close to fully discharged. It is best to fully discharge the batteries at least once a month.
QUICK START IMPORTANT: Before you can start using your new cordless floor and carpet sweeper, you’ll need to charge it for 7 hours. Fig. 2 Fig. 3 Thank yo for purch the Shar Cordless Floor and Carpet Sweeper Fig. 1 ASSEMBLE CLEAN 1 Assemble the upper and lower handle into the elbow joint to form the Shark® Backsaver™ folding handle. Then insert it into the base of your cordless floor and carpet sweeper. (fig.
ou hasing rk® s d Fig. 6 Fig. 4 r Fig. 5 EMPTY 5 The Shark® Backsaver™ folding handle makes cleaning under furniture a breeze. Just press the button on the handle with your thumb to engage the Shark® Backsaver™ function. (fig. 4) 6 When you’re finished cleaning, empty the No-Touch dust cup. Simply press the dust cup release pedal and lift out the dust cup. (fig. 5) 7 Over a trash can, empty the dust cup by pressing the bottom-empty button on the lower portion of the handle.
ASSEMBLY A C B G F E D a H b I Fig. 1 Fig. 2 COMPONENTS: A Floor and Carpet Sweeper Base B Speed Control Button C On/Off Button D Upper Pole with Handle E Backsaver™ Release Button F Shark® Backsaver™ Joint G Lower Pole ASSEMBLY OF YOUR FLOOR AND CARPET SWEEPER: 1 Slide the upper pole (the tube with the handle) into the end of the Shark® Backsaver™ joint that has a small notch in it (a). Then slide the lower pole into the other end of the joint (b). Push it in until it clicks into place. (fig.
USING YOUR CORDLESS FLOOR AND CARPET SWEEPER Fig. 3 Fig. 5 FLOOR CARPET Fig. 4 1 Press the On/Off button to start the floor and carpet sweeper. The lights on the base will illuminate. When finished cleaning, press the On/Off button again to turn the unit off. (fig. 3) Fig. 6 2 You can adjust the speed of the brush roll to suit the floors that you are cleaning. Press the button on the right (opposite the On/Off button) to switch between speeds.
CHARGING YOUR CORDLESS FLOOR AND CARPET SWEEPER OFF Fig. 8 Fig. 7 1 Always make sure that the unit is turned off. (fig. 7) 2 Insert the charger plug into the hole on the back of the floor and carpet sweeper base. (fig. 8) Plug the charger into a wall outlet. The light next to the On/Off button will illuminate when the unit is charging. If the unit is plugged in and the light is not illuminated, press the On/Off button once. The light should now be illuminated indicating that the unit is charging.
MAINTENANCE 3 Fig. 15 Fig. 18 Fig. 13 Fig. 16 Fig. 14 1 Once a month, wipe down your unit with a dry cloth, including the area under the dust cup. Wipe away any hair, fiber or other dirt that may have built up in the chamber and on the rotating brush. Do not use any harsh sweeper or chemicals. 2 Do not immerse your floor and carpet sweeper in water or use it to pick up liquids or clean wet floors. (Fig. 13) 3 Do not use it on concrete, tar or other rough surfaces.
TROUBLESHOOTING GUIDE & REPLACEMENT PARTS PROBLEM POSSIBLE REASONS AND SUGGESTED SOLUTION The cordless floor and carpet sweeper will not operate Batteries need to be recharged. Batteries are dead and need to be replaced. There is no power in the electrical outlet being used. Try to charge using a different outlet. Ensure the wire terminal connectors on the battery pack are securely attached. Clear any obstruction from the rotating brush.
WARRANTY & PRODUCT REGISTRATION EURO-PRO ONE-YEAR (1) LIMITED WARRANTY EURO-PRO Operating LLC warrants this product to be free from defects in material and workmanship for a period of one (1) year from the date of the original purchase, when utilized for normal household use, subject to the following conditions, exclusions and exceptions.
Copyright © 2013 Euro-Pro Operating LLC USA: Newton, MA 02459 CANADA: Ville St-Laurent, QC H4S 1A7 Printed in China Illustrations may differ with actual product. V2950 32_130403.5 Euro-Pro and Shark, are trademarks of Euro-Pro Operating LLC. www.sharkclean.
