V1950 N OWNER’S GUIDE www.sharkclean.com V1950_N_32_ENG_IB_100928.
IMPORTANT SAFETY INSTRUCTIONS CONTENTS For Household Use Only READ ALL INSTRUCTIONS BEFORE USING YOUR SHARK® CORDLESS FLOOR AND CARPET CLEANER. TO MAXIMIZE THE LIFE OF YOUR NI-CD BATTERIES: Quick Start 4 harge for 24 hours before initial use. Failure C to do so will reduce the product’s battery life significantly. Assembly 6 Charging Your Cordless Floor & Carpet Cleaner 7 2 After first use, discharge the unit fully and then recharge for 16 hours.
QUICK START IMPORTANT: Before you can start using your new cordless floor and carpet cleaner, charge it for 24 hours. 24 18 HOURS 6 NOTE: The charging adapter will be shipped inside the packaging. 12 Fig. 4 Fig. 2 Fig. 3 Fig. 1 Fig. 5 ASSEMBLE CLEAN 1 A ssemble the upper and lower poles into the elbow joint to form the Shark® Backsaver™ folding handle. Then insert it into the top of the unit. (Fig.
ASSEMBLY CHARGING YOUR CORDLESS FLOOR AND CARPET CLEANER OFF A B C D Fig. 4 Fig. 3 NOTE: Charge the batteries for 24 hours before first use. 1 A lways make sure that the unit is turned off. (Fig. 3) a G E H I F b Fig. 1 Fig. 2 J 2 I nsert the charger plug into the hole on the side of the unit. Plug the charger into a wall outlet. The light next to the power button will illuminate when the unit is charging.
MAINTENANCE USING YOUR CORDLESS FLOOR AND CARPET CLEANER -cont’d 3 T o clean under furniture, use the Shark® Backsaver™ folding handle. Press the handle release button and apply a bit of pressure to bend the handle forward. (Fig. 7) The Shark® Backsaver™ joint will release from the locked position to reach messes under furniture. (Fig. 8) 6 D o not use the unit to pick up pieces of string or fabrics. Do not use the unit to clean tasseled or frayed carpets. Fig.
TROUBLESHOOTING GUIDE WARRANTY & PRODUCT REGISTRATION PROBLEM POSSIBLE REASONS AND SUGGESTED SOLUTION The unit will not operate Batteries need to be recharged. Batteries are dead and need to be replaced. There is no power in the electrical outlet supplying the charging adapter. Try to charge using a different outlet. Ensure the wire terminal connectors on the battery pack are securely attached. Clear any obstruction from the rotating brush. Turn unit off for 10 seconds, and then restart.
Copyright © 2010 Euro-Pro Operating LLC USA: Newton, MA 02459 CANADA: Ville St-Laurent, QC H4S 1A7 Printed in China Illustrations may differ with actual product. V1950.E.100928 www.sharkclean.com 1-800-798-7398 V1950_N_32_ENG_IB_100928.
