Operation Manual

5
www.sharkclean.com
fig. 10
fig. 11
fig. 12
fig. 13
Using the Steam Energized
™
Cleanser:
1 Make sure that the batteries are inserted into
the battery compartment behind the reusable
bottle. See page 3.
2 Press the Spray Button to apply solution onto the
floor that is to be cleaned. (Fig. 12, Fig. 13)
3 If the Cleanser Bottle is empty, you can replace it
at any time as long as the unit is unplugged from
the electrical outlet.
IMPORTANT: Never leave the Professional
Steam & Spray
™
Mop with a damp/wet cleaning
pad on any floor surface for any amount of time
as this may damage the floor.
4 Once finished, step on the tab at the back of
the cleaning pad and lift the unit to remove the
cleaning pad.
Using Steam:
1 Press the Steam Control button to start the
steam mop. (Fig. 10)
2 Wait 30 seconds for the boiler to heat the water.
Pump the handle a few times to prime the pump,
activate steam and moisten the cleaning pad.
3 Clean your floors with a forward and backward
motion. (Fig. 11)
3 Press the Steam Control button until the light
flashes to stop the steam.
WARNING: Never stand on the Professional
Steam & Spray
™
Mop.
4 When the water tank is empty, the steam mop
will stop producing steam. You can refill the
water tank at any time as long as the mop is
unplugged from the electrical outlet. Follow
instructions on page 4.
IMPORTANT: The Steam & Spray Mop
™
must
be plugged in to use the steam function.