Operation Manual

5www.sharkclean.com
USE
IMPORTANT: Your Easy Spray
™
Steam Mop
needs water to make steam! Never use your Easy
Spray
™
Steam Mop without water in the tank.
Sweep or vacuum your floors before using your
Easy Spray
™
Steam Mop. Your Easy Spray
™
Steam
Mop was designed to get rid of stuck-on gunk,
grime, paw/footprints and it will do a better job
if yesterday’s cereal crumbs aren’t in the way.
Now comes the part you’ve been waiting for – it’s time to use your Easy Spray
™
steam mop. When you
use your steam mop for the first time or haven’t used the unit in awhile, it may take a minute or two
for the water to make its way through the pump and into the heater to create steam. Get it started
by pumping the handle a few times. If you’ve waited a few minutes and you still don’t see any steam,
reference the troubleshooting section on page 8.
fig. 5
Visit www.sharkclean.com for other great
quick cleaning products to complement your
Easy Spray
™
Steam Mop.
1 Pull and twist the quick release cord holder to
unwrap the power cord completely. Plug into an
electrical outlet. The LED light around the Shark
®
logo will turn on. Success! If your light doesn’t
turn on reference the Troubleshooting section on
page 8.
(fig. 5)