Quick Start Guide

1
2
(Click)
Please be sure to read the enclosed Shark® instructions prior to using your unit.
ASSEMB LY
A
Steam Mop Handle
B
Steam Mop Body
C
Removable Handheld
Steamer
D
Intelli-Mop™ Head
E
Dirt Grip™ Pad (x2)
F
Filling Flask
G
Accessory Hose
H
Garment Steamer
(Certain Models Only)
I
Small Above-Floor
Pocket Tool and Pad
(Certain Models Only)
J
Steam Blast Scrubbing
(Certain Models Only)
K
Copper Brush
(Certain Models Only)
L
Nylon Brush
(Certain Models Only)
M
Carpet Glider
(Certain Models Only)
N
Steam Crevice tool
(Certain Models Only)
B
D
C
WHAT’S INSIDE
FILLING THE WATER TANK
REMOVING THE PAD
F
1 Open the water tank cap.
2 Use the filling flask to pour
water into the tank. Do not
overfill. Replace the cap on the
water tank.
S6005UK_QSG_MP_191213_Mv1
1 Screw the mop handle into the Steam Mop body
(screwdriver not included).
2 Slide the Intelli-Mop™ Head connector into the
Steam Mop body. Push until you hear it click
securely into place.
E
A
KLIK N’ FLIP® MOP HEAD TECHNOLOGY
Lift the mop straight
up by the handle
until the Mop Head
is hanging straight
down. Press the pad
release button, and
both sides of the head
will drop open,
releasing the pad.
CAUTION: It is recommended that you allow the
pads to cool o before removing them from the
mophead or accessories to avoid possible
scalding injury.
1 Lift the mop straight
up by the handle
until the Mop Head
is hanging straight
down. Center the
Mop Head above the
pad. Press the release
button on the back
of the mop body, and
both sides
of the mop head will
drop open.
2 Slip the mop head’s
4 corner tabs into
the 4 corner
pockets of the
Dirt Grip™ Pad.
3 Gently press the Mop
Head to the floor on
one side of the pad,
and that side will click
into place.
4 Flip the other side
of the head over
onto the floor to
click into place.
QUICK START GUIDE
FLOOR AND HANDHELD STEAM CLEANER
(Flathead
screwdriver
required -
not included)