User Manual

6sharkclean.com
Assembling Your Steam Pocket
®
Mop
WARNING: Always make sure the Steam Mop is
UNPLUGGED when not in use. Never fill the Steam
Mop or attach the mop head when the Steam Mop
is plugged into an electrical outlet. Unplug from
the electrical outlet and allow to cool before you
fill the mop, or attach or remove the head. To
prolong the life of your Steam Mop, we recommend
using distilled water. Make sure you add only
water to the tank. Chemicals or cleaning solutions
(including vinegar) may damage the Steam Mop
and could be unsafe for you and your family.
STEAM MOP ASSEMBLY
1 Insert the mop handle into the Steam Mop body.
Push the mop handle in until you hear it click into
place. (fig. 1)
2 Slide the Genius
™
Mop Head into the Steam Mop body.
Push until you hear it click securely into place. (fig. 1)
To detach the Genius Mop Head, press the release
button and slide off.
3 To attach the Dirt Grip
™
pad, spread the pad on the
floor with the pocket side up. Center the Genius
Mop Head above the pad, then press the pad
release button on the back of the Steam Mop body
(fig. 2a). Both sides of the Genius Mop Head will
drop open (fig. 2b). Slip the Genius Mop Head’s
four corner tabs into the four corner pockets of the
pad (fig. 3 and fig. 4). Gently press one side of the
Genius Mop Head to the floor until that side clicks
into place (fig. 5). Repeat on the other side (fig. 6).
4 Pull down on the water tank lid to open (fig. 7).
5 Use the filling flask to pour water into the water tank
(fig. 8). Water can be poured into the tank directly. Do
not overfill past the water line on the fill flask. Press
the water tank lid firmly to close it.
fig. 1
fig. 7
fig. 8
fig. 3fig. 2b
fig. 2a
fig. 5 fig. 6
fig. 4