Operation Manual

FILL
4 Lay the mop on the floor or on a counter top and
remove the water tank cap by turning counter
clockwise. Fill the water tank using the filling
flask. Do not overfill the water tank. Replace the
water cap and tighten.
IMPORTANT: Make sure your floors are sealed.
Before using the Steam Pocket
®
Mop consult
page 4 for more information.
Quick Start
2
4
When assembling your Steam Pocket
®
Mop there
may be a little water in or around the water tank.
This is because we test all our Steam Pocket
®
Mops 100% before you buy them, so you get a
quality Shark
®
Steam Pocket
®
Mop.
3
1
ASSEMBLE
1 Insert the mop handle into the pump actuator
(the tube that leads to the tank). Push the mop
handle and pump actuator together in until you
hear it click into place.
2 Select a cleaning pad. Fit one side of the pocket
onto the head first, then using the lavender loop,
pull the pocket over the head. Attach the quick
fasteners on the top of the pocket to secure in
place.
3 Snap the mop head into the base to secure
it. Press the release button to exchange mop
heads.
www.sharkclean.co.ukwww.sharkclean.co.uk