S3502UKJR OWNER’S GUIDE
IMPORTANT SAFETY INSTRUCTIONS For Household Use Only WHEN USING YOUR SHARK® STEAM MOP, BASIC SAFETY PRECAUTIONS SHOULD ALWAYS BE FOLLOWED, INCLUDING THE FOLLOWING: READ ALL INSTRUCTIONS BEFORE USING YOUR SHARK® STEAM MOP. DANGER OF SCALDING. Please use caution when using the steam mop. The steam emitted from the steam mop is very hot.
12. DO NOT unplug by pulling on power cord. To unplug, grasp the plug not the power cord. Do not use extension cords or outlets with inadequate current carrying capacity. 13. DO NOT put any objects into openings. Do not use with any opening that is blocked. 14. DO NOT put hands or feet under the steam mop. Unit gets very hot. 15. Use ONLY on flat, horizontal surfaces. Do not use on walls, counters or windows. 16.
Quick Start When assembling your Steam Pocket® Mop there may be a little water in or around the water tank. This is because we test all our Steam Pocket® Mops 100% before you buy them, so you get a quality Shark® Steam Pocket® Mop. 2 1 3 1 4 ASSEMBLE Insert the mop handle into the pump actuator (the tube that leads to the tank). Push the mop handle and pump actuator together in until you hear it click into place. 2 Select a cleaning pad.
QUICK TIP: For easier pushing and pulling, extend the handle length. 6 5 6 PREPARE For your comfort, you can adjust the height of the mop. Just lift the latch on the tube 90 degrees to the open position. Holding the handle, extend the tube to the height that’s right for you and then close latch to locked position. NOTE: Do not leave your Steam Pocket® Mop unattended during use.
This appliance complies with the WEEE-Directive 2002/96/EC on the disposal of electrical and electronic equipment (WEEE). This appliance complies with the European directives for electromagnetic compatibility (EMC) 2004/108/EC and its revisions, as well as Low Voltage Directive (LVD) 2006/95/EC and its revisions. This marking indicates that this product should not be disposed with other household wastes throughout the EU.
Contents Thank you for purchasing the Shark® Steam Pocket® Mop. Getting Started.................................................................................2 Using Your Steam Pocket® Mop......................................................6 Care of Your Steam Pocket® Mop...................................................8 Ordering Replacement Parts .............................................................10 Troubleshooting Guide.....................................................................
Getting Started e When assembling your Steam Pocket® Mop there may be a little water in or around the water tank. This is because we test all our Steam Pocket® Mops 100% before you buy them, so you get a quality Shark® Steam Pocket® Mop.
2 1 IMPORTANT: First things first, always make sure the mop is UNPLUGGED from the wall when not in use. Never fill the mop, attach the mop head, change or remove the micro-fibre pocket when the mop is plugged into the wall. If you have hard water you might want to use distilled water to prolong the life of the Shark® Steam Pocket® Mop. Make sure you only add water to the tank. Chemicals or cleaning solution may damage the appliance and could be unsafe for you and your family.
Getting Started 3 4 3 Snap the mop head into the base to secure it. Press the release button to exchange mop heads. 4 Turn the water tank cap counter clockwise and remove from the tank. Use the filling flask and pour water into the tank. Please don’t overfill. Replace the cap on the water tank by turning clockwise and tightening. 4 www.sharkclean.co.uk IMPORTANT: Don’t use on unsealed wood or unglazed ceramic floors.
5 5 For your comfort, you can adjust the height of the mop. Just lift the latch on the tube 90 degrees to the open position. Holding the handle, extend the tube to the height that’s right for you and then close latch to locked position. QUICK TIP: If you find the Steam Mop difficult to push/pull during use, then simply increase the height of the pole. www.sharkclean.co.
Using Your Steam Pocket® Mop IMPORTANT: Make sure you don’t use the mop without attaching a micro-fibre pocket and adding water to the tank first. When you are using the mop for the first time, it might take longer than the normal 30 seconds to start steaming. Just pump the handle a few times in a downward motion to prime the pump and it should be ready. 2 1 NOTE: Make sure the floors are swept or vacuumed before using the Steam Pocket® Mop.
3 3 When one side of the micro-fibre pocket gets dirty, just flip the mop head and you can quickly start using the other side. Dirt can’t hide on either side. IMPORTANT: Please wait 3-5 minutes for the Steam Pocket® Mop to cool off before switching the mop head or the micro-fibre Steam Pocket®. 4 When the water tank is empty, the Steam Pocket® Mop will stop producing steam. You can refill the water tank at any time as long as the mop is unplugged from the outlet. Follow the instructions from page 4.
Care of Your Steam Pocket® Mop AFTER USE AND STORAGE 1 When you have finished using the Steam Pocket® Mop, and your floors are clean, unplug the cord from the outlet and move it into an upright position. Let the unit cool 2-3 minutes and release steam by pumping the handle several times before removing the micro-fibre Steam Pocket® from the mop head.
Care of Your Steam Pocket® Mop 2 1 40° CARE OF YOUR CLEANING PAD 1 We recommend washing your cleaning pad separately from other fabrics to avoid picking up lint. Only use liquid detergent (no powder detergent). Do not use any fabric softeners or bleach. Line dry. Do not tumble dry. DECALCIFYING YOUR STEAM MOP Calcium and mineral deposits can build up and impact the performance of your steam mop over time. To extend the life of your product we recommend that you use distilled water.
Ordering Replacement Parts ORDERING REPLACEMENT PARTS To order additional parts and accessories, feel free to contact us at JML, Unit 1 Eastside Port of Tyne South Shields NE33 5SP info@JMLgroup.co.uk Freephone 0800 781 7831 10 www.sharkclean.co.uk PART 1 2 Micro-fibre Pockets PART NO.
Troubleshooting Guide PROBLEM POSSIBLE REASONS & SOLUTIONS The Steam Pocket Mop will not turn on. ® Your Steam Pocket® Mop should be securely plugged into a 220-240V~ electrical outlet only. Check your fuse or breaker. If your unit still doesn’t work, give us a call Freephone 0800 781 7831. Steam Pocket® Mop will not make steam. Steam Pocket® Mop leaves water on the floor. Steam Pocket® Mop is hard to push. Prime the pump, see page 6 for more information.
Notes 12 www.sharkclean.co.
Notes www.sharkclean.co.
JML, Unit 1 Eastside Port of Tyne South Shields NE33 5SP info@JMLgroup.co.uk Freephone 0800 781 7831 www.sharkclean.co.uk Registered address: JML House, NW5 3EG Technical Details Model number: S3502UKJR 11 Input: 1550 Watts Main unit voltage: 220-240V~, 50/60 Hz Printed in China Illustrations may differ from actual product. S3502UKJR.E.120418.2 Not to be disposed of with other household waste.
