www.SharkVacThenSteam.com VAC-THEN-STEAM™ MV2010WC OWNER’S GUIDE MV2010WC_11_IB_ENG_100803.
IMPORTANT SAFETY INSTRUCTIONS For Household Use Only WHEN USING YOUR SHARK® VACTHEN-STEAM™, BASIC SAFETY PRECAUTIONS SHOULD ALWAYS BE FOLLOWED, INCLUDING THE FOLLOWING: WARNING: TO REDUCE 8. To protect against a risk of electric shock, DO NOT immerse the appliance into water or any other liquids. 9. DO NOT handle plug or appliance with wet hands or operate appliance without shoes. THE RISK OF FIRE, ELECTRIC SHOCK OR INJURY READ ALL INSTRUCTIONS BEFORE USING YOUR SHARK® VAC-THEN-STEAM™. 10.
English Steam Technology Contents Thank you for purchasing the Shark® Vac-Then-Steam™, the complete bare floor cleaning system. Getting Started: Assembly 2 Getting Started: Mode Controls 4 Vacuum Mode 5 The unique steam technology, turns simple tap water into super-heated steam that infuse the micro-fiber pads for chemical free cleaning. Only this method creates and delivers 212°F steam that is effective enough to clean and sanitize all your hard floor surfaces.
English Getting Started: Assembly i When assembling your Vac-Then-Steam™ there may be a little water in or around the water tank. This is because we quality test all our Shark products before distributing them, so you get a quality Shark® Vac-Then-Steam™.
Getting Started: Vacuum and Steam Panel English Vacuum Mode STEAM MODE: The Vac-Then-Steam™ has two operating modes: 1 VACUUM MODE: After inserting the telescopic handle, your cleaning system is vacuum-ready. Begin vacuuming your hard-surface floors by tilting the cleaning unit back and pressing the vacuum power button. 3 1 1 2 DO NOT USE STEAM PAD AND FRAME IN VACUUM MODE 2 2 3 3 1 2 OPERATING IN VACUUM MODE: Remove steam pad and frame, if attached. See page 11 for instructions.
English Vacuum Mode 3 4 5 2 2 3 1 1 STORAGE 1 Place your foot lightly on the top of the base. Tilt cleaning unit into the upright position. 2 Turn off the vacuum power button and unplug the unit. 3 Wrap cord around cord holders and secure plug. Store cleaning unit in an upright position. 6 TOLL FREE: 1-800-798-7398 MV2010WC_11_IB_ENG_100803.indd 6-7 IMPORTANT: Always carry the Vac-ThenSteam™ by the cleaning unit collar; rather than by the handle.
English Steam Mode Do not use chemicals or detergents in your Vac-Then-Steam™. You only need water to achieve super-heated, sanitizing steam. 1 1 2 3 MAGNETIC CONNECTIONS ASSEMBLY 1 Attach a steam pad onto the bottom of the steam frame, matching the hook and loop fasteners. 2 Place the steam frame/pad assembly on the floor with the magnetic connections facing up. 8 TOLL FREE: 1-800-798-7398 MV2010WC_11_IB_ENG_100803.indd 8-9 2 3 Place the cleaning unit onto the Steam Frame.
English Steam Mode 3 1 1 3 2 1 2 2 STEAM CLEANING 1 Plug in the cleaning unit. Slide the toggle switch to expose the steam power button. 2 Press the steam power button to the ON “I” position. The illuminated red light indicates that the “boiler” is on. Wait 30 seconds for the water to heat up and for steam to be ready. 3 Place your foot lightly on the top of the base. TILT HANDLE BACK TO ACTIVATE STEAM PUMP. 4 Push handle upright to stop steam.
English Maintaining Your Vac-Then-Steam™ 3 1 Thin Filter Thick Filter Replacement filter sets have been provided with your product. Use one of the replacement filter sets when another set is drying. 1 A replacement post-motor filter has been provided with your product. Use the replacement filter while the other is drying. 2 3 2 24 CARE OF YOUR DUST CUP FILTERS 1 Turn OFF “O” and then unplug the vacuum. Pull out the dust cup. See page 7 for instructions.
Troubleshooting Guide PROBLEM POSSIBLE REASONS & SOLUTIONS The Vac-Then-Steam™ will not turn on. The Vac-Then-Steam™ will not make steam. Your Vac-Then-Steam™ should be securely plugged into a 120V AC electrical outlet only. Check your fuse or breaker. Switch Steam or Vacuum Power button to the ON “I” position. Make sure the water tank is filled to the indicated fill line. Attach Steam Pad and Frame to base of the unit. Switch Steam Power button to the ON “I” position.
Euro-Pro Operating LLC US: Newton, MA 02459 CAN: Ville St-Laurent, QC H4S 1A7 1-800-798-7398 www.SharkVacThenSteam.com Copyright © 2010 Euro-Pro Operating LLC Printed in China Illustrations may differ from actual product. MV2010WC.E.100803 MV2010WC_11_IB_ENG_100803.
