WWW.SHARKCLEAN.COM LIGHT & EASY™ STEAM MOP S3250W series OWNER’S GUIDE S3250W_11-S3250W3_11_IB_ENG_100817.
IMPORTANT SAFETY INSTRUCTIONS SAVE THESE INSTRUCTIONS For Household Use Only 1. Use the system only for its WHEN USING YOUR SHARK® intended use. STEAM MOP, BASIC SAFETY 2. DO NOT use outdoors. PRECAUTIONS SHOULD ALWAYS 3. DO NOT leave the appliance BE FOLLOWED, INCLUDING THE unattended when plugged in. Always unplug the power cord FOLLOWING: WARNING: from the electrical outlet when not in use and before servicing. TO REDUCE 4. DO NOT allow the appliance to be THE RISK OF FIRE, ELECTRIC used as a toy.
11. DO NOT unplug by pulling on power cord. To unplug, grasp the plug not the power cord. Do not use extension cords or outlets with inadequate current carrying capacity. 12. DO NOT put any objects into openings. Do not use with any opening blocked. 13. DO NOT put hands or feet under the steam mop. Unit gets very hot. 14. Use ONLY on flat, stable horizontal surfaces. Do not use on walls, counters, windows, chairs or tables. 15.
Quick Start fig. 3 fig. 1 1 2 ASSEMBLE Fit the extension tubes together as shown in the illustration. (fig. 1) Place the micro-fiber cleaning pad underneath the mop head, with quick fastener strips facing up. Simply press the mop to the pad to attach it. (fig. 2) fig. 2 3 FILL Remove the cap to fill the water tank. Use the filling flask and funnel to fill the tank with water to the “MAX” fill line. Replace the water tank cap. (fig. 3) TOLL FREE: 1-800-798-7398 S3250W_11-S3250W3_11_IB_ENG_100817.
Quick Start fig. 5 fig. 4 STEAM CLEANING 4 Plug in the mop. Wait 30 seconds for the unit to heat up and the steam to be ready. Push the handle toward the mop head in a pumping motion. Customize steam output by slow or fast mopping with a forward and backward motion. (fig. 4) BACKSAVER 5 Use the Shark® Light & Easy™ with backsaver benefit to access tight areas. Press the release button on the handle to lock the Light & Easy™ Steam Mop in the backsaver position.
This manual covers model numbers: S3250W 11 S3250W3 11 TECHNICAL SPECIFICATIONS Voltage: 120V., 60Hz. Power: 1550 Watts Water Capacity: 250 ml (8 oz.) TOLL FREE: 1-800-798-7398 S3250W_11-S3250W3_11_IB_ENG_100817.
Contents Thank you for purchasing the Shark® Light & Easy™ Steam Mop. GETTING STARTED.................................................................. 2 USING YOUR STEAM MOP....................................................6 STORAGE AND CARE OF YOUR STEAM MOP............ 9 TROUBLESHOOTING..............................................................11 WARRANTY AND REGISTRATION....................................13 www.sharkclean.com S3250W_11-S3250W3_11_IB_ENG_100817.
Getting Started When assembling your steam mop there may be a little water in or around the water tank. This is because we test all our steam mops 100% before you buy them, so you get a quality Shark® Light & Easy™ Steam Mop. c b a d f e fig. 1 a Upper Handle Tube with Backsaver benefit b Lower Tube c Steam Mop Base d 2 All-Purpose Cleaning Pads e Filling Flask f Funnel 2 ASSEMBLY 1 Remove all the parts from the package. Verify all the listed parts are included.
English fig. 2 3 Insert the assembled handle piece into the steam mop base. Push the tube base together until you hear a click. (fig. 2) IMPORTANT: Never use the Light & Easy™ Steam Mop without attaching a micro-fiber cleaning pad to avoid damage to your floor and mop. www.sharkclean.com S3250W_11-S3250W3_11_IB_ENG_100817.
Getting Started Your micro-fiber cleaning pads should be replaced every 3 months to maximize cleaning performance. fig. 1 ATTACHING THE MICRO-FIBER PAD 1 Place the micro-fiber cleaning pad on the floor with the quick fastener strips facing up. Place the Light & Easy™ Steam Mop on the top of the pad to attach. (fig. 1) Replacement micro-fiber pads are available at www.sharkclean.com or by calling 1-800-798-7398. IMPORTANT: Only add water to the tank.
English fig. 2 fig. 3 FILLING THE WATER TANK IMPORTANT: Unplug the Light & Easy™ Steam Mop before filling the water tank with water. (fig. 2) 1 Remove the water tank cap by turning it counter-clockwise to the unlocked position. (fig. 3) 2 A filling flask and funnel are included with your Light & Easy™ Steam Mop to make filling the water tank easy. Fill the flask with water and use the funnel to pour it into the tank. Keep the water level under the “MAX” fill line. (fig.
Using Your Light & Easy™ Steam Mop fig. 1 When you use your steam mop for the first time or if you have not used the unit in awhile, it may take a minute or two for the water to travel through the pump and into the heater to create steam. Get it started by pumping the handle a few times. If you have waited a few minutes and you still do not see any steam, reference the troubleshooting section on page 11. fig. 2 fig.
English If your Light & Easy™ Steam Mop stops steaming, it could be out of water. Unplug the power cord from the electrical outlet and refill the water tank at anytime. fig. 4 fig. 5 2 Wait 30 seconds for the boiler to heat the water. Pump the handle a few times to prime the pump, activate steam and moisten the micro-fiber pad. (fig. 4) 3 Mop with a forward and backward motion to customize steam output automatically. (fig. 5) www.sharkclean.com S3250W_11-S3250W3_11_IB_ENG_100817.
Using Your Light & Easy™ Steam Mop fig. 1 1 Clean under furniture and tight areas using the Shark® Backsaver™ locking handle. Press the handle release button and apply slight pressure to bend the handle. The Shark® Backsaver™ joint will lock at a perfect, access-maximizing angle. (fig. 1) 2 Press the release button on the handle again to straighten. 8 TOLL FREE: 1-800-798-7398 S3250W_11-S3250W3_11_IB_ENG_100817.
English Care of Your Light & Easy™ Steam Mop fig. 1 fig.2 AFTER USE AND STORAGE 1 When you have finished using the Light & Easy™ Steam Mop, unplug the cord from the outlet and place the mop into the upright position (fig. 1) and let the unit cool 2-3 minutes. Release steam by pumping the handle several times. 2 Carefully separate micro-fiber cleaning pad from steam mop, avoiding contact with the hot pocket or dirt. (fig. 2) fig.
Care of Your Light & Easy™ Steam Mop fig. 5 fig. 6 CARE OF YOUR MICRO-FIBER CLEANING PAD 1 Wash pads in warm water. Wash separately from other laundry. Only use liquid detergent (no powder detergent). Do not use fabric softeners. Line dry or dry on a low dryer setting. (fig. 5) 2 If there are loose threads on the pad carefully cut the threads with scissors. Do not pull on them or cut at the base. (fig.
English Trouble Shooting PROBLEM The Light & Easy™ Steam Mop will not turn-on. POSSIBLE REASONS & SOLUTIONS Your steam-mop should be securely plugged into a 120V AC electrical outlet only. Check your fuse or breaker. If your unit still does not work, call 1-800-798-7398. Light & Easy™ Steam Mop will not make steam. Is there water in the water tank? If not, add water to your Steam Mop following instructions on page 5. Light & Easy™ Steam Mop leaves water on the floor.
Notes 12 TOLL FREE: 1-800-798-7398 S3250W_11-S3250W3_11_IB_ENG_100817.
English ONE (1) YEAR LIMITED WARRANTY EURO-PRO Operating LLC warrants this product to be free from defects in material and workmanship for a period of one (1) year from the date of the original purchase, when utilized for normal household use, subject to the following conditions, exclusions and exceptions. If your appliance fails to operate properly while in use under normal household conditions within the warranty period, return the complete appliance and accessories, freight prepaid.
Euro-Pro Operating LLC US: Newton, MA 02459 CAN: Ville St-Laurent, QC H4S 1A7 English: 1-800-798-7398 www.sharkclean.com COPYRIGHT© EURO-PRO OPERATING LLC 2010 PRINTED IN CHINA Illustrations may differ from actual product. S3250W/W3.E.100817 S3250W_11-S3250W3_11_IB_ENG_100817.
