Owner's Manual

sharkclean.comsharkclean.com
Select surface setting:
O O
I Hard Floor
For hard floors and small area rugs.
II Carpet
For carpets.
NOTE: All accessories are compatible with both the wand and the handle. Included accessories will vary by model.
NOTE: Brushroll spins in all modes
WHOLE-HOME CLEANING
CLEANING MODES
Step on the pedal on the floor nozzle to lift
o the pod.
Press the Wand Release button and pull up on
the wand to detach it from the pod.
Press the Handle Release button and pull up on
the handle to detach it from the wand.
Attach an optional cleaning accessory to
handle or wand.
LIFT AWAY MODEPOWER/SURFACE SWITCH
INDICATOR LIGHT
ABOVE-FLOOR—WAND
ACCESSORIES—WAND
ABOVE-FLOOR—HANDLE
ACCESSORIES—HANDLE
Wand
Release
WHOLE-HOME CLEANING
SETTINGS
BRUSHROLL INDICATOR LIGHT
The Suction Control Slider located on the handle
allows you to adjust the suction depending on the
floor type.
MIN: to reduce suction and increase
maneuverability on carpets.
MAX: to increase suction on hard floors.
SUCTION CONTROL
To engage Brushroll, turn power on,
select a surface setting, then step on
floor nozzle and tilt handle back.
UPRIGHT MODE
NOTE: For deep carpet cleaning per ASTM F608 (embedded dirt in carpets) set to MAX suction and use setting II, Carpet.
WHAT DOES THE BRUSHROLL INDICATOR LIGHT MEAN?
Solid Green: The brushroll is spinning and working as intended.
Solid Red: There is a jam in the brushroll area. Turn o and unplug the vacuum and remove any
blockages in the nozzle.
Flashing Red: The motorized floor nozzle is overheating. Turn o the vacuum, unplug it, and
remove any blockages. Let the vacuum cool down for at least 60 minutes before restarting.
See Troubleshooting section for more information.