Instructions

15sharkclean.co.uk14 sharkclean.co.uk
Slide the Soft Roller access button
forward to release the Soft Roller.
Hand wash the Soft Roller as needed.
Use only water, and allow it to air-dry
completely for at least 24 hours. Reinsert
the Soft Roller in the front of the nozzle
until it clicks into place.
CLEANING THE SOFT ROLLER
MAINTENANCE
CHECKING FOR BLOCKAGES
Detach hose from vacuum pod, and check
hose and opening on back of pod for
blockages.
Detach wand from floor nozzle and handle,
and check both ends for blockages.
Detach wand from floor nozzle, tilt nozzle
neck back, and check opening for blockages.
To access the nozzle hose, open the locks
on the bottom of the nozzle. With a coin,
turn the locks counterclockwise, then lift the
cover and clear any blockages.
Detach handle from wand and the hose
from the vacuum pod, and check openings
for blockages.
ANTI HAIR WRAP BRUSH-ROLL
If any hair is wrapped around the brush-roll, continue vacuuming using Carpet/Low Pile mode
on a bare floor surface, a low-pile carpet, or a small area rug. This will allow the Anti Hair Wrap
brush-roll to remove the hair wrap and send it to the dust cup.
If you run over a hard or sharp object or notice a noise change while vacuuming, check for
blockages or objects caught in the brush-roll.
If some fibres remain wrapped around the brush-roll after continued use, clear them from the
brush-roll.
NOZZLE MAINTENANCE
HOSE BLOCKAGE WAND BLOCKAGE
POD BLOCKAGE
HANDLE/HOSE BLOCKAGE
NOZZLE HOSE BLOCKAGE
NOTE: Torch not included