Instructions

11sharkclean.co.uk10 sharkclean.co.uk
NOTE: All accessories are compatible with both the wand and the handle.
OPERATING THE VACUUM
CLEANING MODES
To engage brush-rolls, step on floor nozzle
and tilt handle back.
Press power button to turn on vacuum.
Please note the brush-rolls will not spin
until you have stepped on the floor nozzle
and tilted the handle back.
WHAT DOES THE BRUSH-ROLL INDICATOR LIGHT MEAN?
Solid Green: The brush-rolls are spinning and working as they should.
Solid Red: There is a jam in the brush-roll area. Turn o the vacuum and unplug it, then remove
any blockages in the nozzle.
Flashing Red: The motorised floor nozzle is overheating. Turn o the vacuum, unplug it, and
remove any blockages. Let the vacuum cool down for at least 60 minutes before restarting.
See Troubleshooting section for more information.
Press the Wand Release button to detach the
wand from the pod.
Thick Carpet & Area Rug Cleaning
Slide the surface switch to the top position
to select Thick Carpet/Area Rug.
Carpet & Low Pile Cleaning
Slide the surface switch to the middle position
to select Carpet/Low Pile to increase the
speed of the brush-rolls and to help remove
stuck-on dust and debris.
Hard Floor Cleaning
Slide the surface switch to the bottom
position to select Hard Floor.
With pod removed, press the Wand Release
button to detach the wand from the floor
nozzle.
Press the Handle Release latch to detach the
handle from the wand.
Press the Powered Lift-Away® button to
detach the pod from the floor nozzle.
UPRIGHT
POWER SWITCH
INDICATOR LIGHT
ABOVE-FLOOR—HANDLE
POWERED LIFT-AWAY®
ABOVE-FLOOR—WAND
SURFACE
LIFT-AWAY®
OPERATING THE VACUUM
SETTINGS
BRUSH-ROLL INDICATOR LIGHT
NOTE: Try using Hard Floor mode for low pile area rugs.