Operator`s manual

DGA • 8.918-695.0 • Rev. 01/14
OPERATOR’S MANUAL
PRESSURE WASHER
8
ASSEMBLY INSTRUCTIONS
STEP 1: Insert rotary joints into
frame tubes so that stops point
away from engine. Then fi x them
using 1/4" bolts and nuts on each
side and tighten.
STEP 2: Adjust handle at the de-
sired position.
STEP 4: Attach the high pressure
hose to the spray gun using tefl on
tape on hose threads.
STEP 7: Release the coupler collar
and push the nozzle until the collar
clicks. Pull the nozzle to make sure
it is seated properly.
STEP 8: Connect the high pres-
sure hose to the discharge nipple.
Push coupler collar forward until
secure.
STEP 5: Attach wand to spray gun
using tefl on tape on wand threads.
STEP 6: Pull spring-loaded collar
of the wand coupler back to insert
your choice of pressure nozzle.
STEP 9: Connect garden hose to
the cold water source.
STEP 10: Check inlets filters,
remove debris, then connect the
garden hose to pump water inlet.
CAUTION: Do not run the pump
without water or pump damage
will result.
Rotary
Tube-Joint
Handle
Bolt
Nut
Frame
Assy
Safety
Latch
Spray
Gun
High
Pressure Hose
Wand
Spray
Gun/Wand
Wand
Coupler
Pressure
Nozzle
Pressure
Nozzle
Wand
Coupler
Coupler
Collar
Discharge
Nipple
High
Pressure
Hose
Cold
Water
Source
Garden
Hose
Pump
Water Inlet
Garden
Hose
Coupler Collar
STEP 3: Use the nut and washer to
attach the hose hanger.
Hose
Hanger
Nut
Washer