Specifications

BG SERIES PRESSURE WASHER OPERATOR’S MANUAL
7
Fuel Valve Lever
ON
OFF
Choke Lever
CLOSED
OPEN
OPERATING INSTRUCTIONS
1. Read provided engine manual warning and operat-
ing instructions.
2. Pull wand coupler collar
back and insert pressure
nozzle into coupler then
secure by pushing collar
forward to lock.
3. Turn on water at faucet and squeeze spray gun trig-
ger allowing water to flow until a steady stream
comes out of wand.
4. Move the fuel valve lever
to the ON position. Turn
the fuel valve lever to the
OFF position after stop-
ping engine.
5. To start a cold engine,
move the choke lever to
the CLOSED position.
To restart a warm en-
gine, leave the choke
lever in the OPEN po-
sition.
6. Turn the engine switch to
the ON position.
7. Open spray gun before pull-
ing the starter grip.
8. To start the engine pull
the starter grip lightly un-
til you feel resistance,
then pull briskly. Return
the starter grip gently.
CAUTION: Pull trigger on spray gun to relieve pres-
sure if machine does not start after one pull of starter
grip.
CAUTION: Small engines may kick back. Do not hold
starter grip tightly in hand.
9. With the spray nozzle pointed away from you or any-
one else, press the trigger on the spray gun to ob-
tain pressurized spray.
SHUTDOWN PROCEDURES
1. If a detergent injector was used, flush all lines with
clean water to remove soap residue.
2. Turn off engine. Turn off water supply.
3. Squeeze spray gun trigger to relieve any pressure.
4. Disconnect water supply hose from washer.
CAUTION: Do not allow pump to run without water.
5. Disconnect all hoses to allow water to drain. Protect
from freezing.
CAUTION: Do not allow pump to run longer than
3 minutes without water. Disconnect all hoses to
allow water to drain.
CAUTION: With machine off, open spray gun to
release pressure before removing discharge hose.
GENERAL WASHING
TECHNIQUES
Test pressure and spray pattern on hard surface (i.e. ce-
ment) to gauge distance and impact of water spray.
Hold spray nozzle
approximately one
foot from surface be-
ing cleaned. For best
surface cleaning ac-
tion, spray at slight
angle.
To change spray
nozzle for a different pattern it is recommended that you
turn off engine and squeeze spray gun trigger to release
hose pressure. Pull back on quick coupler at end of wand
and exchange nozzle. Make sure nozzle is seated se-
curely. Restart engine.
Use the detergent injector to apply detergent. Wash from
the bottom and work up. Allow the detergent to set 5-10
minutes on surface. Rinse from top down.
NOTE: If pressure washer is running and not being
used for more than 2 minutes, turn off engine.
Wand
Spray Nozzle
Quick Coupler
1 Foot
Wand
Starter Grip
Engine Switch