Operating instructions

Page 4 Shark B2535H/1
Figure 2 - Pressure Hose Installation
Figure 3 - Trigger Gun/Dual Lance Wand
ASSEMBLY
Unpacking
Unpack carefully. Wear safety glasses or goggles while
unpacking, assembling, or operating pressure washer. If
there are missing components or hidden damage, imme-
diately contact carrier concerning discrepancies.
Parts Included
• Pressure Washer
• Pressure Hose
• Pressure Nozzle (4 Ea.)
• Wand
• Trigger Gun
• Operating Instructions and Parts Manual
• Gasoline Engine Manual
Pressure Hose, Trigger Gun and Wand
1. Install the pressure hose on the pressure washer as
shown in Figure 2.
2. Assemble wand components as shown in Figure 3.
NOTE: The pressure nozzle is not to be installed at
this time.
3. Make sure all connections are secure.
INSTALLATION
Getting Started
IMPORTANT: Proper initial installation of equipment
will assure more satisfactory performance, longer ser-
vice life, and lower maintenance cost.
IMPORTANT: The use of a backflow preventer on the
water supply hose is recommended and may be
required by local code.
The pressure washer should be run on a level surface
and in a protected area where it is not readily influenced
by outside forces such as strong winds, freezing tem-
peratures, rain, etc. The pressure washer should be
located to assure easy access for filling of fluids, adjust-
ments and maintenance. Normal precautions should be
taken by the operator to prevent moisture from reaching
the pressure washer. It is recommended that a partition
be made between the wash area and the pressure washer
to prevent direct spray from the wand from coming in con-
tact with the pressure washer. Moisture reaching the
equipment will reduce the pressure washer’s service life.
All installations should comply with the local codes
covering such installations.
PRESSURE HOSE
PRESSURE HOSE
CONNECTOR
TRIGGER GUN
WAND
PRESSURE HOSE