Instruction Manual

17sharkclean.co.uk16 sharkclean.co.uk
MAINTENANCE
CHECKING FOR BLOCKAGES
Detach hose from vacuum pod, and check
hose and opening on back of pod for
blockages.
Detach wand from floorhead and handle, and
check both ends for blockages.
Detach wand from floorhead, tilt floorhead
neck back, and check opening for blockages.
Detach handle from wand and the hose
from the vacuum pod, and check openings
for blockages.
HOSE BLOCKAGE WAND BLOCKAGE
POD BLOCKAGE
HANDLE/HOSE BLOCKAGE
NOTE: Torch not included
ANTI HAIR WRAP BRUSH-ROLL
If any hair is wrapped around the brush-roll, continue vacuuming using Carpet/Low Pile mode
on a bare floor surface, a low-pile carpet, or a small area rug. This will allow the Anti Hair Wrap
brush-roll to remove the hair wrap and send it to the dust cup.
If you run over a hard or sharp object or notice a noise change while vacuuming, check for
blockages or objects caught in the brush-roll.
If some fibres remain wrapped around the brush-roll after continued use, clear them from the
brush-roll.
FLOORHEAD MAINTENANCE
Slide the Soft Roller access button forward
to release the Soft Roller.
To minimise the risk of power cord damage,
DO NOT run the vacuum over the power cord.
If this occurs, immediately shut o power to
the vacuum and remove the cord from the
brushroll or floorhead.
Hand wash the Soft Roller as needed. Use
only water, and allow it to air-dry completely
for at least 24 hours. Reinsert the Soft Roller
in the front of the floorhead until it clicks into
place.
1. DO NOT pull or carry vacuum cleaner by
the cord or use cord as a handle.
2. DO NOT unplug by pulling on the cord.
Grasp the plug, not the cord.
3. DO NOT close the door on the cord.
4. DO NOT pull the cord around sharp
corners.
5. DO NOT leave the cord near heated
surfaces.
CLEANING THE SOFT ROLLER
CORD MAINTENANCE
To access the floorhead hose, pinch the
release touchpoints on the bottom of the
floorhead, then lift the cover and clear any
blockages.
FLOORHEAD HOSE BLOCKAGE