Instruction Manual

13sharkclean.co.uk12 sharkclean.co.uk
NOTE: All accessories are compatible with both the wand and the handle.
OPERATING THE VACUUM
CLEANING MODES
To engage brush-rolls, step on floorhead and
tilt handle back.
Press the Wand Release button to detach the
wand from the pod.
With pod removed, press the Wand Release
button to detach the wand from the
floorhead.
Press the Handle Release latch to detach the
handle from the wand.
Press the Powered Lift-Away button to
detach the pod from the floorhead.
UPRIGHT
ABOVE-FLOOR—HANDLE
POWERED LIFT-AWAY®
ABOVE-FLOOR—WAND
LIFT-AWAY®
OPERATING THE VACUUM
SETTINGS
NOTE: Try using Hard Floor mode for low pile area rugs.
WHAT DO THE HEADLIGHT INDICATOR LIGHTS MEAN?
Solid White Lights: The brushrolls are spinning and unit is working as it should.
Solid Red Lights: There is a jam in the brushroll area. Turn o the vacuum and unplug it, then
remove any blockages in the floorhead.
Flashing Red Lights: The motorised floorhead is overheating. Turn o the vacuum, unplug
it, and remove any blockages. Let the vacuum cool down for at least 60 minutes before
restarting. See Troubleshooting section for more information.
Flashing White Lights: The vacuum is operating in an environment that is either too hot or too
cold. This vacuum will only function properly in temperatures ranging from 0°C (32°F) to 40°C
(104°F). Turn the vacuum o and adjust the room temperature.
HEADLIGHT INDICATOR LIGHTS
HEADLIGHTS
The headlights will flash or turn red to
indicate issues that need attention.
Press power button to turn on vacuum. Please
note the brush-rolls will not spin until you
have stepped on the floorhead and tilted the
handle back.
Thick Carpet & Area Rug Cleaning
Slide the surface switch to the top position
to select Thick Carpet/Area Rug.
Carpet & Low Pile Cleaning
Slide the surface switch to the middle position
to select Carpet/Low Pile to increase the
speed of the brushrolls and to help remove
stuck-on dust and debris.
Hard Floor Cleaning
Slide the surface switch to the bottom
position to select Hard Floor.
POWER SWITCH SURFACE SELECTOR
NOTE: Try using Hard Floor mode for low pile area rugs.