User manual

This can come in quite handy in a situation where The Shark has already been installed

with some remote equipment, or in some hard-to-reach location. Simply use the Shark

Config program to establish a Bluetooth

wireless connection with your Shark over the

virtual COM port used by your Bluetooth

wireless enabled device. Then begin to use

the setup software as you would when connected via a RS-232 serial cable over the

physical COM port. However, the setup program in this mode will be limited to the

following changes:

o Friendly Name

o Security Mode (enable/disable)

o PIN

o Baud Rate

o Flow Control

These limitations are due to the fact that your Shark will already be set up as a slave

device and as such the Device Discovery will be unusable. You also will not be able to

change the operating role from Slave to Master.