User manual

2004 Stevens Water Monitoring Systems Inc. All Rights Reserved.
22
Figure 10: During a Connection Attempt
o During the connection attempt, you may click Cancel to stop the
attempt. Cancel takes 5-10 seconds to complete while the device resets
itself.

Figure 11: Connection Success!
o Upon a successful connection, this message box pops up to confirm the
Bluetooth
®
SIG qualified product address and friendly name of the
connected device. 
o If you are unable to connect, and if your Master and/or Slave device has
Security Mode Enabled, please make sure the PIN numbers are the same.
(See section 3.3.2 above). You may want to test connection by selecting
“Disable” under the Security Mode for both the Master and the Slave
device.
