PHONE: 800-355-4945 EMAL: info@energyproducts.biz WEB: www.energyproducts.
PHONE: 800-355-4945 EMAL: info@energyproducts.biz WEB: www.energyproducts.
PHONE: 800-355-4945 EMAL: info@energyproducts.biz WEB: www.energyproducts.biz IMPORTANT! BOILERS ARE TO BE USED FOR RADIANT FLOOR HEATING ONLY! THIS MANUAL MUST BE READ CAREFULLY BEFORE ATTEMPTING TO INSTALL THE HYDRO-SHARK BOILERS. IF YOU DO NOT FOLLOW THE SAFETY RULES OR THE INSTRUCTIONS OUTLINED IN THIS MANUAL, THE UNIT MAY NOT OPERATE PROPERLY AND IT COULD CAUSE PROPERTY DAMAGE, SERIOUS BODILY INJURY AND/OR DEATH. STIEBEL ELTRON, INC.
PHONE: 800-355-4945 EMAL: info@energyproducts.biz WEB: www.energyproducts.biz MOUNTING THE UNIT SH3-12, SH3-14, SH3-19, SH3-24, SH3-29 & SH3-36 UNIT MUST BE INSTALLED IN A VERTICAL POSITION WITH THE WATER FITTINGS POINTING DOWNWARD, DO NOT INSTALL UNIT WHERE IT WOULD ROUTINELY BE SPLASHED WITH WATER OR ELECTRICAL SHOCK MAY RESULT. 1. Leave a minimum of 5” of Clearance on all sides for servicing. 2. Make sure that the Power is Off. 3. Remove the Cover. 4.
PHONE: 800-355-4945 EMAL: info@energyproducts.biz WEB: www.energyproducts.biz MOUNTING THE UNIT SH3-3 & SH3-10 UNIT MUST BE INSTALLED IN A VERTICAL POSITION WITH THE WATER FITTINGS POINTING DOWNWARD, DO NOT INSTALL UNIT WHERE IT WOULD ROUTINELY BE SPLASHED WITH WATER OR ELECTRICAL SHOCK MAY RESULT. 1. Leave a minimum of 5” of Clearance on all sides for servicing. 2. Make sure that the Power is Off. 3. Remove the Cover. 4. Mount securely to wall by putting four screws through mounting holes. 5.
PHONE: 800-355-4945 EMAL: info@energyproducts.biz WEB: www.energyproducts.biz FLUID CONNECTIONS NOTE: EXCESSIVE HEAT FROM SOLDERING COPPER PIPES NEAR THE BOILER MAY CAUSE DAMAGE. 1. All plumbing work must comply with the national, state, local & any other applicable codes. 2. Make sure the radiant floor system has been purged & is free of floating debris. 3. The return side (inlet) is on the right side of the unit, the supply side (outlet) is on the left of the unit. 4.
PHONE: 800-355-4945 EMAL: info@energyproducts.biz WEB: www.energyproducts.biz ELECTRICAL CONNECTIONS WARNING: BEFORE BEGINNING ANY WORK ON THE ELECTRIC INSTALLATION, BE SURE THAT THE MAIN BREAKER PANEL SWITCHES ARE “OFF” TO AVOID ANY DANGER OF ELECTRIC SHOCK. ALL MOUNTING AND PLUMBING MUST BE COMPLETED BEFORE PROCEEDING WITH ELECTRICAL HOOK-UP. WHERE REQUIRED BY LOCAL,STATE OR NATIONAL ELECTRICAL CODES THE CIRCUITS SHOULD BE EQUIPPED WITH A “ GROUND FAULT INTERRUPTER”. 1.
PHONE: 800-355-4945 EMAL: info@energyproducts.biz Figure A SH3-07 & SH3-10 Figure B SH3-12 8 WEB: www.energyproducts.
PHONE: 800-355-4945 EMAL: SH3-29,SH3-36 SH3-36 SH3-24 info@energyproducts.biz SH3-14,SH3-19,SH3-24 WEB: www.energyproducts.
PHONE: 800-355-4945 EMAL: info@energyproducts.biz WEB: www.energyproducts.biz TECHNICAL DATA “A” MODEL - 14 1/4 H X 7 7/8 W X 4 1/8 D - 1/2 PLUMBING FITTINGS MODEL KW BTU VOLTS AMPS BRKR WT-LBS SH3-07 7.2 24,573 240 30 (1)40 5.9 SH3-10 9.6 32,764 240 40 (1)50 5.9 “B” MODEL - 14 1/2 H X 16 5/8 W X 4 5/8 D - 3/4 PLUMBING FITTINGS MODEL KW BTU VOLTS AMPS BRKR WT-LBS SH3-12 12 40,968 240 50 (1)70 17 SH3-14 14.4 49,161 240 60 (2)40 20 SH3-19 19.
PHONE: EMAL: 800-355-4945 WEB: info@energyproducts.biz www.energyproducts.
PHONE: 800-355-4945 EMAL: info@energyproducts.biz WEB: www.energyproducts.biz WARRANTY RESIDENTIAL & COMMERCIAL WARRANTY: STIEBEL-ELTRON WARRANTS TO THE ORIGINAL OWNER THAT ALL BOILERS (SH3-SERIES) WILL BE FREE FROM DEFECTS IN WORKMANSHIP AND MATERIALS FOR A PERIOD OF THREE YEARS FROM THE DATE OF PURCHASE. SHOULD THE PART(S) PROVE TO BE DEFECTIVE UNDER NORMAL USE DURING THIS PERIOD STIEBEL-ELTRON, INC. WILL BE RESPONSIBLE FOR THE REPLACEMENT OF THE DEFECTIVE PART(S) ONLY. STIEBEL-ELTRON,INC.
PHONE: 800-355-4945 EMAL: info@energyproducts.biz 13 WEB: www.energyproducts.
PHONE: 800-355-4945 EMAL: info@energyproducts.biz 14 WEB: www.energyproducts.
PHONE: 800-355-4945 EMAL: info@energyproducts.biz 15 WEB: www.energyproducts.
PHONE: 800-355-4945 EMAL: info@energyproducts.biz 16 WEB: www.energyproducts.
PHONE: 800-355-4945 EMAL: info@energyproducts.biz 17 WEB: www.energyproducts.
PHONE: 800-355-4945 EMAL: info@energyproducts.biz 18 WEB: www.energyproducts.
PHONE: 800-355-4945 EMAL: info@energyproducts.biz 19 WEB: www.energyproducts.
PHONE: 800-355-4945 EMAL: info@energyproducts.biz WEB: www.energyproducts.biz FILLING THE SYSTEM The pH of a system is a measure of the hydrogen concentration. The higher the reading the more basic the solution, the lower the PH the more acidic the solution. The pH scale ranges from 1-14 with a ph of 7 being neutral. The proper pH of a system can have a great effect on the overall life of the system. The pH of a system should be kept between 9 and 10.5 for optimum operational life.
PHONE: 800-355-4945 EMAL: info@energyproducts.biz I. FILLING THE SYSTEM A. System is assembled, it is time to fill it. WEB: www.energyproducts.biz OVERVIEW OF A TYPICAL SYSTEM B. Fill the system until there are no air bubbles in it. Air bubbles cause circulator pumps and element failures. C. Purge the system one loop at a time. Open one loop with all of the other loops closed repeat down the manifold. Purge each loop untill no air is seen in the discharge/fill tank. II. SOLUTION A.
PHONE: 800-355-4945 EMAL: info@energyproducts.biz 4. Attach the third hose (blue) to valve “C” located above the primary circulator. Put the other end into the fill tub. This valve “C”should be open allowing water to circulate through the floor and all of the loops back to the bucket where it started. The bucket must have fluid in it at all times while filling. As the water returns the fluid may be milky, this is air in the solution.
PHONE: 800-355-4945 EMAL: WEB: info@energyproducts.biz www.energyproducts.biz V. FINISH FILLING A. Water has turned from milky to clear. B. NO air bubbles are seen. C. Close the discharge ball valve. D. Keep pumping until pressure on the guage is 15-20 Lbs. E. Turn off the fill valve. F. Shut off the pump, the system should be free of air and at pressure. VI. PRESSURE MAINTENANCE SYSTEMS FOR CLOSED LOOP SYSTEMS (Recommended) A. Limited volume and unlimited volume 1.
