Specifications

benchmarkwireline.com
P. O. BOX 850
Fax: [phone]
Phone: [phone]
Simonton,Texas 77476
36220 FM 1093
SHARK MANUAL Rev H Page 12 of 34 Aug 2009
4.0 MAINTENANCE AND REPAIR
4.1 PRE AND POST JOB CHECKS
Between jobs, check the measuring and guide wheels for looseness, play, out-of-
roundness, worn or rough sounding bearings, or other mechanical conditions that
could affect measurement accuracy.
Visually inspect the interiors of the electrical connectors for the encoders and
electronic load axle for dirt and evidence of insulation breakdown. Clean or
replace as necessary. Install dust caps on the connectors if the cables are
removed.
Manually rotate each wheel by hand to verify its condition. Inspect the depth
measuring wheel for signs of abnormal wear diameter changes, or shaft play that
can affect measurement accuracy. The wheel should be replaced if it is grooved
more than .005".
Inspect the tension wheels for signs of abnormal wear, diameter changes, or shaft
and bearing play that could affect measurement accuracy. It should also be
replaced if it is grooved more than .005".
Do not pressure wash