Instruction manual

Presser Foot Lifter

a. Presser foot lifter

b. Normal up position

c. Highest position

The presser foot lifter raises and lowers the presser foot.

You can raise it about 1/4” (0.6 cm) higher than the normal

up position for easy removal of the presser foot or to allow

you to place heavy fabric under the presser foot. (Fig. 1)

Changing the Presser Foot

d. Lever

e. Groove

f. Pin

To Remove:

1. Turn the handwheel towards you to raise the needle to

its highest position.

2. Raise the presser foot.

3. Press the presser foot release lever on the back of the

foot holder. The presser foot will drop.

To Attach:

1. Place the new presser foot so that the pin on the top of

the foot lines up directly below the groove of the foot

holder. (Fig. 2)

2. Lower the foot holder to lock the foot in place.

Extension Table

g. Extension table

h. Tab

i. Hole

To Detach the Extension Table:

1. Pull the extension table away from the sewing machine.

(Fig. 3) Use the free-arm for sewing cuffs and sleeves.

You can use the extension table as a storage container

to store all of the accessories.

To Attach the Extension Table:

1. Push the extension in until it snaps into place.

Fig. 1

Fig. 2

Fig. 3