Specifications

e Electro Industries/GaugeTech Doc # E145701 7-10
7.3.4: Operating Mode
Q
Operating Mode is the Shark 100 meter’s Default Mode. After Start Up, the meter automatically
scrolls through these parameter screens, if scrolling is enabled. The screen changes every 7 seconds.
Scrolling is suspended for 3 minutes after any button is pressed.
Q
Push the DOWN Button to scroll all the parameters in Operating Mode.
The ‘Active” parameter has the Indicator light next to it on the right face of the meter..
Push the RIGHT Button to view additional readings for that Parameter.
A Table of the possible readings for Operating Mode is below.
See Appendix A (Sheet 2) for the Operating Mode Navigation Map.
NOTE: Reading or Groups of readings are skipped if not applicable to the meter type or hookup, or if
explicitly disabled in the programmable settings.
Parameter
Designator
Available by
V-Switch
VOLTS L-N V1-4 VOLTS_LN
VOLTS_LN_
MAX
VOLTS_LN_
MIN
VOLTS L-L V1-4 VOLTS_LL
VOLTS_LL_
MAX
VOLTS_LL_
MIN
AMPS V1-4 AMPS
AMPS_
NEUTRAL
W/VAR/PF V2-4 W_VAR_PF
W_VAR_PF
_MAX_POS
W_VAR_PF
_MIN_POS
W_VAR_PF
_MAX_NEG
W_VAR_PF
_MIN_NEG
VA/Hz V2-4 VA_FREQ
VA_FREQ_
MAX
VA_FREQ_
MIN
Wh V3-4 KWH_REC KWH_DEL KWH_NET KWH_TOT
VARh V3-4
KVARH_
POS
KVARH_
NEG
KVARH_
NET
KVARH_
TOT
VAh V3-4 KVAH
Possible Readings
OPERATING MODE PARAMETER READINGS
AMPS_MAX
VOLTS_LN
_THD
V4 Only
AMPS_THDAMPS_MIN