Specifications

e Electro Industries/GaugeTech Doc #: E145701 3-3
3.3: DIN Installation Steps
DIN INSTALLATION STEPS:
1. Slide meter with NEMA 12 Mounting Gasket into panel. (Remove ANSI Studs, if in place.)
2. From back of panel, slide 2 DIN Mounting Brackets into grooves in top and bottom of
meter housing. Snap into place.
3. Secure meter to panel with lock washer and a #8 screw through each of the 2 mounting
brackets. Tighten with a #2 Phillips screwdriver. Do not overtighten.
Shark 100 Meter
with NEMA 12
Mounting Gasket
Remove (unscrew)
ANSI Studs for
DIN Installation
DIN Mounting
Bracket
Top Mounting
Bracket Groove
Bottom Mounting
Bracket Groove
#8 Screw
Figure 3.8: DIN Mounting Procedure