Specifications

E Electro Industries/Gauge Tech Doc# E145721 E-4
11. When the
driver installation
is
complete
, you will see the screen shown below.
12. Click
Finish
to close the
Found New Hardware Wizard
.
IMPORTANT! Do NOT remove the Installation CD until the entire procedure has been
completed.
13. Position the
USB to IrDA Adapter
so that it points directly at the
IrDA
on the front of the Shark
®
100 meter. It should be as close as possible to the meter, and not more than 15 inches/38 cm away
from it.
14. The
Found New Hardware Wizard
screen opens again.