User`s manual

64
WARNING: do not touch the extruder, even while it’s warming up, since it reaches temperatures up to 230° c. Similarly, do not touch the building plan that can
be heated up to 110° c.
WARNING: do not touch the lament of melted material, but wait until it cools down and solidies.
4.1 Arrest
To stop the machine at any time you need to move the power switch to the 0 position – OFF and then pull the plug to the wall.
5 | Manutention and Demolition
To ensure maximum reliability to the machine and prevent hazardous conditions observe the instructions and warnings given on the following pages.
DANGER: for security reasons, all maintenance operations given in this chapter should be performed only by qualied and specially trained technicians.
The technicians must also have all the tools and PPE necessary to operate safely.
DANGER: all cleaning and maintenance work on the machine must be carried out with the power switch to the 0 position – OFF and wall plug disconnected.
DANGER: before you intervene on the machine wait for cooling all parts which may reach high temperatures (even 210° C), or the extruder, building plan, the
strand of melted material, the material just settled.
All environmental-impact materials that you need to delete aer servicing must be disposed of according to the regulations.
In any case, to carry out all the maintenance or cleaning below at the machine, you will need the following personal protective equipment:
Please refer also to the instructions regarding the residual risks and specic warnings in section 3.3.4.
5.1 Troubleshooting, diagnosis and maintenance
To solve some problems and maintenance and cleaning tasks for your Desktop 3D printer SHAREBOT NG, visit www.sharebot.it under “support”>”How to”.
DANGER: be careful not to cut yourself in case the plan is of glass, always use gloves.
NOTE: for more detailed information about troubleshooting or solve any other problems check the how-to section on the website www.sharebot.it.
Refer to how-to sections of the web site www.sharebot.it to learn whether text that you will also nd videos on channel SHAREBOT on youtube.
Remember that in case of need you can send an email to [e-mail] stating exactly your problem.
5.2 Extraordinary Maintenance
Each intervention, such as the replacement of components, must be carried out in collaboration with SHAREBOT technicians. Get in touch with SHAREBOT sup-
port via email [e-mail].
5.3 Decommissioning, dismantling and demolition
To perform disassembly and demolition you will need the following personal protective equipment:
For the decommissioning of the machine for a long time, perform the following steps: