User`s manual

63
3.3. Installation
WARNING: the manufacturer declines all responsibility for damages to things and/or people resulting from improper interventions carried out by unqualied,
untrained or unauthorized use.
To perform the task under consideration requires the following personal protective equipment:
Please refer also to the instructions regarding the residual risks and specic warnings.
3.3.1 Connection to electricity supply
WARNING: make sure that the circuit-breaker/isolator on the printer is in “0” position, i.e. turned o.
CAUTION: If the operating voltage is not responding to its demands, it is necessary to apply a transformer.
- Connect the power cable to the printer.
- Connect the power cable to the power socket on the wall.
- The socket-outlet must be installed near the equipment and shall be easily accessible
Additional warnings about the connection to the power supply:
- You need to install a suitable protection dierential type upstream of the point of connection of the electric power of the machine, in order to isolate each
element in case of faults in the operation; the choice of dierential protection device should not be inconsistent with the provisions of the law, with local regula-
tions, with the characteristics of the electrical system of the settlement and of the machine itself.
WARNING: the manufacturer declines all responsibility for damages to things and/or people resulting from improper interventions performed by unqualied
people, not trained, untrained or not authorized.
3.4. Storing
In case you need to keep for a period of time the machine before make install (or uninstall), it is recommended that you protect it properly and store it in a suit-
able environment, having the following characteristics:
- external surfaces are resistant to atmospheric agents;
- protected against access by unauthorized persons;
- equipped with xed oor drain water, free from vibrations and passable to vehicles and liing equipment;
- with the following environmental conditions:
- good ventilation;
- room temperature between -20° C and +50° C;
- relative humidity between 30% and 80%;
- in dry and dusty atmosphere.
4 | Starting and using the machine
WARNING: he manufacturer declines all responsibility for damages to things and/or people resulting from improper interventions performed by unqualied
people, not trained, untrained or not authorized.
To perform the tasks of commissioning of the machine you will need the following personal protective equipment: