User`s manual
40
Just in case you have a dual-extruder and NG please make a double press extruder, load the prole
“SharebotDualstrusion”. Otherwise unnecessarily heating energy sprechereste the second extruder.
In the conguration le we included parameters related to all three tabs to allow you to have a start-
ing point for reliable and experienced. If you want to create dierent proles, you can adjust the
individual parameters and save congurations with a new name. We recommend that you do not
overwrite the basic proles provided by Sharebot.
Loading the model to print
In the tab “Plater” click on “Add” and upload your 3D model in STL format; Alternatively you can also
drag it within the program from an open folder. Will Center automatically Slic3r le without lay it on
printing: If your STL was created adjacent to the XY plane printing is doomed to failure.
You can upload multiple STL or upload multiple times the same STL doing what in jargon is called “im-
piattato”. For the dailies we recommend you try one le at a time.
Basic parameters of Slic3r
As seen earlier, Sharebot NG allows (thanks to proles PLA and ABS) generating G-Code by setting only
the geometric parameters of our interest: we can create not specic G-Code to individual materials,
leaving then set all the parameters of temperature, fans, etc., to determine the material to be used.
From this perspective, the basic parameters are those that go to geometric illustrate.
For further information please see Slic3r manual (manual.slic3r.org) and our courses (www.sharebot.
it/academy).