User`s manual

36
Modifying printing parameters
One of the features of Sharebot NG is the ability to intervene on a number of parameters while print-
ing is in progress.
The “Adapt” menu becomes available instead of the “Prepare” (see Chapter 3): This allows you to
adapt the selected prole PLA or ABS or normal to their compatible materials for behavior and char-
acteristics (v. Materials table in Chapter 7), changing the nozzle plate temperature and the fan speed.
Speaking at the feed rate example you can slow down or speed up the overall printing speed to han-
dle any contingencies as a material that requires more time to cool (and therefore should be printed
more slowly) or a model that can be achieved at higher speed. Another important parameter is the
ow rate that percentage increases or decreases the amount of material extruded, compensating for
any changes in the diameter of the wire than that stated by the manufacturer. The ow rate can also
thicken or thin the walls of the model.
The “Fan” makes it possible to adjust the airow on the piece in print.
Detaching the 3D printed object
Finished your print, Sharbot NG put the printing plate down and park your extruder. In this location
there is easy access to print plan to detach from it the nished object.
This operation is delicate and inevitable: because the object is printed, it is necessary that its rst
layer adheres well and remains clinging to the plane for the duration of the press itself. If there was a