User`s manual
35
heated oor, fans turned o).
Once selected the prole displays the contents of the SD Card both in terms of le and folders. By
turning the knob, you can scroll to the le you want. Pressing the knob you select for printing.
Your Sharebot NG will start with the heating phase and by positioning the origin of the axes, then
when it reaches the temperature you do in a central area of the press and will start with the rst layer.
Check that the lament sticking to the oor without being crushed nor too, it only supported and
then round. If you have successfully run the calibration you will have no problems; on the contrary it
should stop printing and redo calibration.
Stopping the print
When printing you can pause or abort printing. The two options are available directly from the main
menu as “Pause” and “Stop Press”.
Remember that in the rst case is only blocked the process of creating the layers by stopping the ex-
truder (this may take a few seconds) waiting for you give the command “Resume”.
In the second case the printing stops immediately and can no longer continue. The extruder is posi-
tioned at the beginning of the X and Y coordinates. Unfortunately, the point at which stops the extruder
can be aected by heat and then deform or can a runny agglomero of material from the extruder. So the
break is to be used only in case of need and for short periods.
Please activate it only when the extruder being traced a ll so that the drop is hidden inside the object.