User`s manual

25
The Control knob
To the right of the display is a knob which rotates with small clicks and can be pressed as a button.
With this knob you can interact with Sharebot NG: clockwise you decrease the selected value, turning
it anti-clockwise will increase.
During menu scrolling, rotation anticlockwise ows downward, that hourly rate upward.
When the display is on the screen information, described at the beginning of this chapter, the rota-
tion of the knob acts on Feed Rate percentage, increasing or decreasing the speed of all the move-
ments and therefore also the printing speed.
Access to principal menu
Pressing the knob of the screen information, accessing the main menu. Remember that the menu
displayed depends on the State of the printer if it is waiting to run a business, oers the menu “pre-
pare”, while if you are printing oers the menu “t”. The voices and the features available in these
two modes are dierent and it is important to know how you are to avoid to lose time looking for
functions that are of other mode.
1° level active printer
Main Menu
Prepares
SD Card Menu
Reset
1° level printer in print
Main Menu
Adapt
Pause
Stops Printing
Reset
“Prepare” Menu
This menu is used to set up and manage the printer for subsequent operations such as printing or
shutting down. From here you can upload and download print, wire extruders, Preheat to 0.0 ex-
truder positioning or movement of the extruder on the plane. In practice, you have complete control
and can perform all management and maintenance operations. In the next chapter we will use this
menu to adjust the printing surface.