User`s manual

24
Chapter 3
LCD Panel
Sharebot NG is a printer that supports both stand-alone operation and control from one computer
(OS X, Windows or Linux). In both cases the LCD Panel provides functions both for consultation which
edited.
Informative mode
When the printer is on, he is by printing or waiting for a job, has about 20 rows to 4 characters with
the following information:
The rst line contains the actual extruder temperature followed by one set; If the extruders are two,
the rst is on the le while the latter is right. What is used as the primary extruder is the one on the
right. The temperature is in degrees Celsius.
The second line indicates le the temperature of heated plate with a le sidebar and current tem-
perature right one set; right in the second row is the current position of the print, or z-axis. The value
is in millimetres, with two decimals indicate hundredths of millimeter.
The third row has le the percentage Rate or Feed than expected print speed within the G-Code les
(and then set as a parameter of slicing) is increased or decreased in percentage. The 100% does not
alter the speed of movement set; lower values will slow down the speed and higher values increase
the speed.
On the same line in the Center is the percentage for printing a le on SD card: start with 00% at the
beginning of the press to get to 100% when printing is completed. To the right of this is the elapsed
time from the start of printing, expressed in hours and minutes.
The fourth line contains messages that can be generated by the G-Code le with a special command,
or the rmware of the card of specic situations.