User`s manual
16
Opening the package
Your Sharebot NG is equipped with a series of accessories that allow you to make it immediately
operative; there is no soware because it is open source and constantly updated. Soware must be
downloaded from the website of Sharebot to always have the latest version.
With care and without damaging the packaging remove the various parts and elements that x the
printer inside the cardboard and then, by the internal metal frame, pull it out.
Do NOT pull the so black lead from the le side and comes to the extruder: it is a power cord and
NOT handle. Proceed with the recovery from the packaging of all the parts and check that the mate-
rial listed below are all in the package:
Warning:
Do not throw away the original package. You could use it if you have to send it or move it.
In the package you’ll nd:
1. Reel-carrier in assembly kit
2. Power cable
3. SD Card with a few object that we loaded for you
4. USB cable
5. 100g of ABS and 100g of PLA
6. Spay
7. Cutter
8. Wire cutter
9. Warranty
10. Our letter of presentation and welcome
11. Glass printing bed and an object that we printed with your printer as a test
Positioning the printer
For proper operation, the printer must work in a clean and dust-free, with an ambient temperature
between 5° C and 35° c. It is also preferable to a position away from dras or air conditioning.
In the back you’ll nd power switch so we recommend to leave it easily accessible while at the front,
bottom le, you will nd the ventilation opening electronic part from which depends the correct
circuit cooling: this must be le unobstructed.
Remember that the wire is usually in a spool and that this should be positioned on the reel-carrier
included in the packaging. The recommended position is behind the printer, on the same oor, but
there are alternative positions that depend on the presence of any walls or shelves near the machine.
The important thing is that the wire is easily accessible and you can even put multiple spools on the