Instructions / Assembly

Well Cover Installation Instructions
1. Place window well cover over well.
2. Mark position of holes for clips on center of well
rim with a marker on the window well cover. Two
(2) clips on each side and one (1) clip on the front
of the well.
3. Remove window well cover and drill a 3/16” hole at
each marked location on window well cover. Do not
drill window well cover when cold, window well cover
should be at room temperature when drilling.
Shape Products, LLC
5205 Freitag Drive
Menomonie, WI 54751
Phone: [phone]
Fax: [phone]
Email: [e-mail]
www.shapeproducts.com
Products
Shape Products, LLC warrants it’s Egress Window Well Covers for a period of seven (7) years from the dated of purchase. This warranty only extends to the original purchaser.
This warranty does not apply to damage from accident, misuse, normal wear, alteration, improper installation, improper maintenance, abuse or excessive weather damage. Any
implied warranties which the purchaser may have are limited in duration to seven (7) years from the date of purchase. Some states do not allow limitation on how long any
implied warranty lasts, so the above limitations will not apply in those states. Shape Products, LLC. will replace a window well cover with a manufacturer’s defect free of charge,
(except for dealer labor and shipping). Contact Shape Products, LLC. Via phone or email listed below ( or see your Shape Products, LLC. dealer) to obtain service under this
warranty. Note proof of purchase and pictures of damage is required, and replacement is the sole remedy of purchaser under this warranty. Shape Products, LLC. will assess
proof to determine whether a replacement is warranted. In no event shall Shape Products, LLC. be liable for any incidental or consequential damages, losses, or expenses. Some
states do not allow exclusion of incidental or consequential damages, so the above limitation or exclusion may not apply in those states. This warranty gives specic rights and
rights may vary per state.
4. Mount clips to window well cover using bolts, and
cap nuts provided. IMPORTANT! Put bolt through clip
and cover. Secure using cap nut that has been provided
(See diagram below).
Cap Nut
Clip
Bolt
Window Well Cover
5. Snap window well cover onto rim of window well.
Adjust spring clips by loosening or tightening cap nuts.
The window well cover should be easy to remove for
cleaning and ventilation.
6. If your window projects above the window well,
please see your Shape Products, LLC. dealer about a
dome cover option.
Cleaning Instructions: Window well covers may be cleaned with a mild non-abrasive solution of detergent and water. The use of harsh
chemicals, solvents, abrasive rags or scrubbers may damage the cover and void the warranty.