Installation Guide

BUBBLE WINDOW WELL COVER

INSTALLATION INSTRUCTIONS

INSTALLATION

1. Place cover over window well

2. Drill (2) mounting holes on both sides of the window well cover through

the plastic flanges. Mark anchor hole locations on both sides of the

window.

3. Determine length and type of anchor screws required.

4. Remove window well cover and drill anchor holes to proper sizes.

5. Position cover over window aligning holes with anchors.

6. Secure the window well cover to the wall using anchors. If gaps occur,

they may be filled in with caulk. NOTE: Make sure to maintain sufficient

ventilation to allow moisture to escape.

WHAT YOU NEED

PRODUCTS

5205 Freitag Drive Menomonie, WI 54751 • 1-866-552-5582 • shapeproducts.com

CLEANING INSTRUCTIONS

Clean your window well cover with a mild solution detergent and

water. Use of harsh chemicals or solvents may damage plastic and void

warranty.

Attachment anchors (not included)