User's Manual

External flash disk:

Insert the flash disk into the USB port. Once it is properly connected, you can save

and copy contents between the device and the PC.

2.9

2.9 Network

Network

Network connection

connection

Cable network:

After you insert the network cable into the port designed for Ethernet on the PC, the

icon “ ETH ” will appear on status bar at the top of the screen. Then the device will

obtain the IP address automatically to access to the network. Network access can

also be realized through manual setups.

Wireless network:

1 ． Move leftward the WI-FI switch at the upper right part of the device to be in the

ON state;

2 ． Select the icon “ setup ” under the shortcut bar on the desktop;

3 ． Select “ wireless network ” in the setup menu;

4 ． Open WI-FI through the check box behind it;

5 ． Select “ WI-FI setup ” to set the WI-FI network;

6. All APs found by the device will be listed. You can click the AP name to be

connected;

7. If the connection is successful before the AP, the information of AP will be saved.

To start connecting, select “ connect ” in the popped-up window. To eliminate the AP

information, select “ forget ” ;