Installation Instructions

 


 
NOTE: This equipment has been tested and found to
comply with the limits for a
Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a
residential installation. This equipment
generates uses and can radiate radio
frequency energy and, if not installed and used
in accordance with the instructions,
may cause harmful interference to radio
communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this
equipment does cause harmful interference to
radio or television reception, which
can be determined by turning the equipment off
and on, the user is encouraged to
try to correct the interference by one or more of
the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment
and receiver.
-Connect the equipment into an outlet on a
circuit different from that to which the
receiver is connected.
-Consult the dealer or an experienced radio/TV
technician for help
Changes or modifications not expressly approved
by the party responsible for compliance could
void the user's authority to operate the
equipment.
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two
conditions:
(1) this device may not cause harmful
interference, and
(2) this device must accept any interference
received, including interference that may cause
undesired operation.